Document Type : Original Article
Authors
1
PhD student in Crop Physiology, Department of Plant Production and Genetics, College of Agriculture, University of Birjand, Birjand, Iran
2
Professor, Department of Plant Production and Genetics, College of Agriculture, University of Birjand, Birjand, Iran
3
Associate Professor, Department of Plant Production and Genetics, Faculty of Agricultural Science and Engineering, Razi University, Kermanshah, Iran
4
Associate Professor, Department of Plant Production and Genetics, College of Agriculture, University of Birjand, Birjand, Iran
Abstract
Introduction
Chickpea (Cicer arietinum L.) is an ancient crop that has been cultivated for centuries in India, the Middle East, and parts of Africa. Chickpea responds well to irrigation, and even under rainfed conditions, supplementary irrigation, particularly during the flowering stage, positively affects crop growth, grain protein content, grain yield, and biological yield. Water scarcity in agriculture has increased the focus on practices that maximize yield per unit of water consumed and optimize the use of available water resources. Regulated deficit irrigation is one such practice in which crops are subjected to a controlled level of water stress during part or all of the growing season to optimize water-use efficiency. In this approach, any slight reduction in yield resulting from mild water stress should be offset by the benefits of reduced water use. Determining the optimal salicylic acid concentration and moisture level is important for achieving appropriate chickpea yields and requires investigation under field conditions. Accordingly, the present study aimed to investigate the effects of different salicylic acid concentrations and moisture levels on grain yield and related traits of chickpea.
Materials and methods
The experiment was conducted during the 2023–2024 growing season at the research farm of the Agricultural and Natural Resources Campus, Razi University, Kermanshah, Iran, using a split-factorial arrangement based on a randomized complete block design with three replications. The main-plot treatments consisted of three irrigation levels, corresponding to 50%, 75%, and 100% (control) of the plant water requirement. The subplot treatments comprised a factorial combination of two chickpea genotypes (Bionige and Mansour) and three foliar salicylic acid concentrations (0, 200, and 400 mg L⁻¹). The water requirement of chickpea was determined using CROPWAT software. Physiological traits, yield, and yield components were measured, including the number of pods per plant, the number of seeds per plant, biological yield, seed yield, seed weight, harvest index, water-use efficiency, protein content, electrolyte leakage, proline content, and chlorophyll content. After normality was confirmed, the data were analyzed using SAS version 9.4, and treatment means were compared using the protected least significant difference (LSD) test at the 5% significance level.
Results and discussion
The results showed that the Bionige cultivar under full irrigation (100% of the plant water requirement) and foliar application of salicylic acid at 200 mg L⁻¹ exhibited the highest values for the number of pods per plant, the number of seeds per plant, the number of two-seeded pods per plant, biological yield, grain yield, water-use efficiency, and 100-seed weight. Mean comparisons also showed that the Bionige and Mansour cultivars had the highest and lowest total chlorophyll contents, respectively, under foliar application of salicylic acid at 200 mg L⁻¹. The lowest grain yield, water-use efficiency, and 100-seed weight were also recorded for the Bionige cultivar under 50% of the plant water requirement and foliar application of distilled water. The higher grain yield of chickpea under full irrigation (100% of the plant water requirement) was attributed to increases in the number of pods per plant, the number of seeds per plant, the number of two-seeded pods per plant, biological yield, water-use efficiency, 100-seed weight, and harvest index. Grain yield depends on the allocation of plant dry matter to reproductive organs, as reflected by the harvest index, as well as on the number of grains set and grain weight. In this study, these traits increased significantly when 100% of the plant water requirement was supplied, particularly in the Bionige cultivar treated with salicylic acid at 200 mg L⁻¹, compared with the other treatments. In addition, biological yield was higher under full irrigation than under irrigation at 75% or 50% of the crop's water requirement and responded positively to salicylic acid application.
Conclusion
Overall, the highest yield was obtained when 100% of the plant water requirement was supplied. Under deficit irrigation, however, supplying less than 75% of the plant water requirement is not recommended. Salicylic acid application also improved chickpea traits, with responses increasing up to 200 mg L⁻¹. However, further evaluation of additional salicylic acid concentrations is required to determine the optimal concentration. Overall, the Mansour cultivar performed better than the Bionige cultivar under deficit irrigation, whereas the Bionige cultivar performed better under full irrigation. In conclusion, the combination of full irrigation supplying 100% of the crop's water requirement and foliar application of salicylic acid at 200 mg L⁻¹ in the Bionige cultivar produced the best overall results and is recommended for chickpea cultivation under similar climatic conditions.
Keywords
Subjects